The Power Lift Unloader is not working
Alicia
Last Update 3 ปีที่แล้ว
| Possible Cause | Solution |
|---|---|
| Battery is not charged | Plug in the charger and leave it for a few hours or overnight. |
| The switch on the handle does not "click" | When you depress the switch to go up the button should spring back and it should make a clicking noise. If the switch seems loose (like a see saw), then you will need a replacement. |
| The light on the charger turns right to green when plugged into the wall. | When the charger is plugged into the control panel and then the plug into the wall the lights on the plug block should start on red even if only for a short time, then it will turn to green. If the light on the charger block goes straight to green, the battery is over-discharged and needs to be replaced. |
| The light on the charger goes from red to green but lifter still not working. | If the light goes from red to green and the switch is operating properly, there is either a bad connection with the wiring or the actuator needs to be replaced. Double check the wiring according to their instructions. If the wiring looks like it is all in the right place and in good condition, replace the actuator. |
| There are no lights on the charger block. | If there are no lights on the plug block once it is plugged into the wall, replacing the charger will be required. |